Paxton Net2 PaxLock Specifications download pdf (Page 2)

Page 2

The lock case and cylinder (not supplied) must rst be tted

to the door, ensuring that a 22-24 mm diameter hole is

drilled for the follower (As shown on the template provided).

Slide the spindle through the lock to allow the template to

locate over it. Ensure that the template is square to the door

edge by using the top and bottom ruler scales.

Mark the 2 x 10 mm, 1 x 16 mm holes. Remove the template

and repeat the procedure for the other side.

Installing the hardware

Step 1 - Marking out

Step 2 - Drilling

Remove the lock if required and drill the 2 x 10 mm holes

for the mounting screws and 1 x 16 mm hole for the wiring

harness.

To ensure accuracy you should drill these holes from both

sides of the door towards the centre. This also avoids the risk

of damaging the door face when the drill breaks through.

Step 3 - Contact switch (optional)

If a contact switch is to be tted, an additional hole is

required in the edge of the door.

Drill a hole of the required size to receive the switch

assembly. This should intersect the 16 mm hole drilled

previously to take the wiring harness.

Feed the contact wires through the door to exit on the inside.

Ø 16

105

Ø 10

Paxton

The spindle is locked into the front lock assembly by means

of a spring loaded pin.

Ensure that the spindle pin and the hole in the square drive

are in alignment before depressing the pin and sliding the

bar into the assembly. The pin will then latch into the hole

securing the spindle in place.

Step 4 - Attach the Spindle

1 2 3 4 5 6 7

No comments

Paxton Net2 PaxLock Specifications Page 2